Idiomas disponibles
Idiomas disponibles
Troubleshooting
Symptom
The CD does not play or
"No disc" appears in the
display when a CD is placed
in the CD player.
"HOLD" flashes on the
display when you press a
button, and the CD does not
play.
Cannot adjust the volume
with VOL +/– on the CD
player.
The CD player does not start
charging.
Playback starts from the point
you stopped. (resume
function)
Rustling noise is heard from
the CD.
32
-GB
Cause and/or corrective actions
c The buttons are locked. Slide the HOLD switch back. (page 25)
c The CD is dirty or defective.
c Check that the CD is inserted with the label side up. (page 11)
c Moisture condensation has occurred.
Leave the CD player aside for several hours until the moisture
evaporates.
c Close the lid of the battery compartment firmly. (page 27)
c Make sure the batteries are inserted correctly. (page 27)
c Connect the AC power adaptor to an AC outlet securely. (page 11)
c Press u after one second or more has passed since the AC power
adaptor was connected.
c The CD-R/RW is blank.
c There is a problem with the quality of the CD-R/RW, recording
device, or application software.
c Files in two or more formats have been recorded on the CD-R/RW.
(page 7)
c The buttons are locked. Slide the HOLD switch back. (page 25)
c The CD player is connected to an audio device. Adjust the volume
using the volume control on the connected device. (page 26)
c During stop, press x/CHARGE. (page 27)
c The resume function is working. To start play from the first track,
press u during stop until the first track starts playing, or open the
lid of the CD player. Or remove all power sources, then insert the
batteries or connect the AC power adaptor again.
(pages 11, 12, 27)
c Close the lid of the battery compartment firmly. (page 27)
