Idiomas disponibles
Idiomas disponibles
8.4.
Drum speed
If the appliance is programmed to run drying cycles without humidity control, HUMIDITY
CONTROL (NO) or to omit the intelligent dry system, INTELLIGENT DRY (NO), this option is
displayed and allows the advanced user to adjust the drum rotation speed. The selected speed is
fixed for the length of the drying cycle and is limited by the variator programming.
The value of this parameter is given as a % of the maximum value that the drum can turn. If
this value is not modified by the user, each dryer model will have a rotation speed corresponding
to the nominal speed.
A table is attached below indicating the nominal speed for each model and the minimum
and maximum limits of the variation range in %. Any value outside these ranges will be omitted by
the software, and the appliance will only operate within the range limits (either the maximum or
minimum limit).
Model
DSC-11/DSC-
17/DSC-23
To maximise safety, the frequency variator of each model is limited by programming to the
minimum and maximum speed values given in this table to prevent these limits from being
exceeded from the configuration of this menu.
8.5.
Low Power Supply
In this configuration, the control limits the use of the two heaters at the same time, so that
the machine never consumes more than 4.7 kW.
DRUM SPEED
85 %
Nominal
Minimum
Nominal
speed
Value
(rpm)
(%)
46
85
LOW POWER SUPPLY
NO / YES
Minimum
speed
Limit (%)
(rpm)
35
65
Maximum
Maximum
speed
Limit (%)
(rpm)
51
95
80
