Hotpoint Ariston FK 61 X /HA Manual De Instrucciones página 26

Care and maintenance
Switching the appliance off
GB
Disconnect your appliance from the electricity supply
before carrying out any work on it.
Cleaning the appliance
• The stainless steel or enamel-coated external parts
and the rubber seals may be cleaned using a
sponge that has been soaked in lukewarm water
and neutral soap. Use specialised products for the
removal of stubborn stains. After cleaning, rinse and
dry thoroughly. Do not use abrasive powders or
corrosive substances.
• The inside of the oven should ideally be cleaned
after each use, while it is still lukewarm. Use hot
water and detergent, then rinse well and dry with a
soft cloth. Do not use abrasive products.
• All accessories - with the exception of the sliding
racks - can be washed like everyday crockery, and
are even dishwasher safe.
! Never use steam cleaners or pressure cleaners on
the appliance.
Cleaning the oven door
Clean the glass part of the oven door using a sponge
and a non-abrasive cleaning product, then dry
thoroughly with a soft cloth. Do not use rough abrasive
material or sharp metal scrapers as these could
scratch the surface and cause the glass to crack.
For more thorough cleaning purposes, the oven door
may be removed:
1. Open the oven door fully ( see diagram ).
2. Use a screwdriver to lift up and turn the small levers
F located on the two hinges ( see diagram ).
*
Only available in certain models.
26
F
3. Grip the door on the two
outer sides and close it
approximately half way. Pull the
door towards you, lifting it out
of its slot ( see diagram ). To
replace the door, reverse this
sequence.
Inspecting the seals
Check the door seals around the oven regularly. If the
seals are damaged, please contact your nearest
Service Centre ( see Assistance ). We recommend that
the oven is not used until the seals have been
replaced.
Replacing the light bulb
To replace the oven light bulb:
diagram ).
Sliding rack kit assembly
A
Left
Right guide
guide rail
rail
B
C
1. Remove the
glass cover of the
lamp-holder.
2. Unscrew the
light bulb and
replace it with a
similar one:
Wattage 25 W,
cap E 14.
3. Replace the
glass cover ( see
To assemble the sliding
racks:
1. Remove the two
frames, lifting them
away from the spacers
A ( see figure ).
2. Choose which shelf to
use with the sliding rack.
Paying attention to the
direction in which the
sliding rack is to be
extracted, position joint
B and then joint C on the
frame.