Enabling The Other Operator; Wheel Spin Counter - Corghi EM 9250 CompactLine Manual De Uso

13. ENABLING THE OTHER OPERATOR

This programme makes it possible for two different operators to use the machine at the
same time due to the presence of two different working environments.
The parameters which remain saved for every working environment are:
- balancing mode (Dynamic, Alu x, Motorcycle etc.);
- wheel dimensions (distance, diameter and width of those relating to the active ALU
programme).
The machine's general settings remain the same for all working environments:
- grams/ounces, sensitivity x1/x5, threshold, etc....
Proceed as follows to recall this programme:
• press the
- use the
• press the
1 first operator
or 2 second operator
- press the
Activation of the second operator is indicated by the illumination of the LED
display panel.
Repeat the procedure described above to return to the first operator.

14. WHEEL SPIN COUNTER

This programme is used to display the total number of spins performed by the machine
since its first start-up (tot SPi), the number of spins performed since the last unbalance
calibration (CAL SPi) and the number of partial spins performed since the machine was
last started (PAr SPi).
Proceed as follows to recall this programme:
• press the
• use the
124
key
keys to search for OPE 1 (or OPE 2 if previously set)
key to change the setting:
key to confirm and exit.
key
keys to search for -SP in-
EM 9250 - EM 9250 C CompactLine Operator's manual
on the