Idiomas disponibles
Idiomas disponibles
xFUME POWER 350
7.3 Switching on the device
► Set the main switch to <I>.
4.1 Assembly and use on page EN-12
7.3.1 Setting the welding mode
The following welding modes are available:
— MIG/MAG welding
— Electrode welding
— TIG welding
► Repeatedly press the <MIG/electrode/TIG> button until the desired welding mode is selected.
Loosen and remove the upper knurled screws.
6
Remove the upper wire feed rollers (including the roller
7
holder and washer) sideways.
Remove the washers and the wire feed rollers from the
8
roller holder.
Insert the new wire feed rollers and washers.
9
Insert the upper wire feed rollers (including the roller
10
holder and washers) from the side.
Tighten the upper knurled screws.
11
Press down the upper flaps on the right and left.
12
Fold up the pressure lever (I).
13
Turn the pressure lever (I) to set the contact pressure for
14
the wire feed rollers so the welding wire is not damaged
and runs smoothly.
7 Operation
EN - 25
