WEG CFW700 Serie Manual Del Usuario página 33

Keypad (HMI) and Basic Programming
Inverter status:
LOC: local reference.
„
REM: remote reference.
„
: motor rotation according to the arrows.
„
CONF: configuration. It indicates that the inverter is in the Oriented Start-up routine or with
„
incompatible parameter programming. Refer section Incompatibility Between Parameters in
the programming manual of the CFW700.
SUB: DC link undervoltage.
„
RUN: inverter enabled and/or DC braking activated.
„
The keypad can be installed or removed from the inverter with or without AC power applied
to the inverter.
28 | CFW700
Monitoring Mode
It is the initial state of the keypad after power up and startup screen, with
„
the factory default values.
The Menu is not active in this mode.
„
Main display, secondary display and monitoring bar show the values of
„
the parameters defined at P0205, P0206 and P0207.
From the monitoring mode, pressing the ENTER/MENU key will switch to
„
the programming mode.
Programming Mode
Level 1:
This is the first level of the programming mode. It is possible to chose the
„
parameter group by using the
The main display, secondary display and monitoring bar are not shown
„
at this level.
Press the ENTER/MENU key to go to the second level of programming
„
mode - parameters selection.
Press the BACK/ESC key to go back to the monitoring mode.
„
Level 2:
The parameter number is displayed on the main display and its value on
„
the secondary display.
Use the and keys to find the desired parameter.
„
Press the ENTER/MENU key to go to level 3 of the programming mode
„
- parameters value changing.
Press the BACK/ESC key to return to level 1 of the programming mode.
„
Level 3:
The parameter values is shown at the main display and the parameter
„
number at the secondary display.
Use the and keys to change the value of the selected parameter.
„
Press ENTER/MENU key to confirm the modification (save the new
„
value) or BACK/ESC key to cancel the modification (do not save the
new value). In both cases, the keypad returns to the second level of the
programming mode.
Figure 4.3: Keypad operation modes
and keys.