Positioning
the telescoping
thread
guide bar
(T_Thread guide
(_) Telescoping thread guide bar
(_) Stoppers
(_) Spool pin
[] Pull the telescoping thread guide bar (_ up as far as it wilt
go.
[] Turn the thread guide bar (_) until it clicks into position.
Thread guides 1_ should stop directly above the
spool pins 0.
NOTE:
Make sure the two stoppers (_ on the thread guide shaft,
as shown, are set in at the correct position,
r
i
I
!
Attaching
the spool
cap and net
C) Spool holder
(_) Spool pin
(_ Spool cap (optional item)
(&) Slit
When you use a small thread spool, remove the spool
holder O from the spool pin @. Then place the spool with
its spit 0 side up, and put spool cap (_) on top..
(_ Spool pin
(_ Net
If the thread slips down from the spool during threading
and / or sewing, put a net (_) on the spool as illustrated to
_revent jamming.
NOTE:
Turn spool holders upside down on pins to hold large
cones of thread securely.
f
J
J
Raising or lowering the presser foot
0 Presser foot lifter
(_) Presser foot
By raising or lowering the presser foot lifter (_, the presser
foot (_ goes up and down..
While in operation, keep the presser foot O lowered. Raise
presser foot when threading the machine or test running
without thread.
NOTE=
Thread tension wilt be released when the presser foot
lifter is raised..
10
Capítulos
