Idiomas disponibles
Idiomas disponibles
18. Machine stop button
19. Throttle control switch
20. 12 V connector (for light kit option)
21. Water pump switch
22. Light kit switch
23. Screwdriver (not included)
24. Blade shaft wrench
25. Hammer
26. Lever for cutting depth adjustment
27. Depth indicator and calibration wheel
28. Lever for speed control. Forward, rearward and stop
position.
29. Differential locking knob
30. Lever for the water cooling system for the cutting
blade
31. Knob for rear axle freewheel function
32. Fuel gage
Symbols on the product
WARNING: This product can be
dangerous and cause serious injury or
death to the operator or others. Be careful
and use the product correctly.
Read the operator's manual carefully
and make sure that you understand the
instructions before you use this product.
Use hearing protection, eye protection
and respiratory protection. Refer to
Personal protective equipment on page
10 .
The dust can cause health problems. Use
an approved respiratory protection. Do not
breathe exhaust fumes. Do not use a
combustion engine product indoors or in
areas that do not have sufficient airflow.
Risk of cut injuries. Keep all body parts
away from the cutting blade.
The blade guards must always be
installed on the product. Do not let more
than 180° of the cutting blade show.
Keep body parts away from the cutting
blade and other moving parts.
6
Make sure that the cutting blade is not
blunt or has damages, such as cracks.
Make sure that the cutting blade is
applicable to the same speed or a
higher speed than the value given on the
product. A cutting blade that is operated at
too high speed can break and cause injury
or damage.
Do not use the product near flammable
material or gases.
Always lift the product at the lifting eye.
The arrow on the blade guard shows the
direction of rotation of the cutting blade.
Risk of injury. Be careful around the
electric fan and other moving parts.
Risk of injury. Be careful around the belt
and other moving parts.
Keep body parts away from the moving
parts of the product.
XX
XXmm
Dimension of the cutting blade.
Dipstick.
Engine start.
Machine stop.
1657 - 004 - 07.03.2022
