Idiomas disponibles
Idiomas disponibles
5. Push the lever for speed control forward for forward
saw movement, or rearward for reverse movement.
The more you push the lever for speed control, the
more the speed increases. Refer to
on page 48 .
To move the product up and down a ramp
WARNING:
move the product up and down ramps with
the engine on. The product is heavy and
there is a risk of injury if the product falls or
moves too quickly.
WARNING:
angle, always use a winch. Do not walk or
stay below the product.
WARNING:
rearward and cause injury or damage. Be
careful when you tilt the product rearward or
lift the product.
WARNING:
down a ramp in freewheel position. Always
move the product forward down ramps and
slopes. Do not walk beside or stay below the
ramp when you move the product down a
ramp.
•
To move the product down a ramp, operate the
product forward slowly.
•
To move the product up a ramp, operate the product
rearward slowly.
To move the product with the engine off
WARNING:
product when the freewheel function is
engaged. The product can move away from
you and cause injury to bystanders.
1657 - 004 - 07.03.2022
Technical data
Be very careful when you
For ramps with a large
The product can easily tilt
Do not move the product
Maintain control of the
CAUTION:
function when the engine is at idle speed or
off. The lever for speed control must be in
the stop position.
1. Turn the ignition key to the "I" position.
2. Push the lever for cutting depth adjustment rearward
until the cutting blade is above the surface.
3. Put the lever for speed control into the stop position.
Only engage the freewheel
45
