Idiomas disponibles
Idiomas disponibles
Problem
Cause
The battery is
The ignition key is not in "0" position when the
drained.
product is not in operation.
The machine stop button is pushed down to stop
the product.
The light kit or the water pump is on when the
product is not in operation.
Transportation
WARNING:
transportation. The product is heavy and can
cause injury or damage if it falls or moves
during transportation.
The wheels let you move the product manually for
shorter distances. For longer distances, lift the product
to move it or put the product on a vehicle.
CAUTION:
behind a vehicle.
•
Safety the product during transportation. Make sure
that it cannot move.
•
Remove the cutting blade before transportation of
the product.
•
Remove all tools and wrenches.
•
For transportation of the product and fuel, make
sure that there are no leaks or fumes. Sparks or
open flames, for example from electrical devices or
boilers, can start a fire.
•
Always use approved containers for transportation of
fuel.
•
Examine new cutting blades for transport damage.
44
Transportation, storage and disposal
Be careful during
Do not tow the product
Solution
Turn the ignition key to the "0" position.
Always use the ignition key to stop the product.
Push down the switch for the light kit to make
the light kit go off. Push down the water pump
switch to disengage the water pump.
To move the product with the engine on
1. Put the lever for speed control into the stop position.
2. Remove the cutting blade. Refer to
cutting blade on page 17 .
3. Start the engine without connect the water to the
To start the product on page 19 .
product. Refer to
4. Push or tap the throttle control switch to correct
engine speed.
To remove the
1657 - 004 - 07.03.2022
