Idiomas disponibles
Idiomas disponibles
DSP 212, DSP 224, DSP 412, DSP 424
8.1
Switching on the inverter
➤ Switch the inverter on by pressing the switch (fig. 2 1, page 3) on the device
(position "I") ...
➤ ... or (DSP412, DSP424 only) switch on the inverter using the external switch
(optional).
✔ The blue Status LED lights up (fig. 2 2, page 3).
✔ The power consuming device is supplied with voltage.
Charging the device via the USB port
I
NOTE
Also observe the operating manual of the device you want to charge via
the USB port.
➤ Connect the device to the USB port as shown (fig. 9, page 7).
8.2
Status indications
The blue LED (fig. 2 2, page 3) shows the operating condition of the inverter.
Display
Constantly lit
Long flash, short interruption
Quick flash
Off
9
Cleaning and caring for the inverter
A
NOTICE! Damage hazard
• Never clean the cooling device under running water or in dish water.
• Do not use abrasive cleaning agents or hard objects during cleaning
as these can damage the cooling device.
➤ Occasionally clean the cooling device interior and exterior with a damp cloth.
➤ Make sure that the air inlet and outlet vents on the device are free of any dust and
dirt, so that heat can be released and the device is not damaged.
EN
Cleaning and caring for the inverter
Input voltage
Normal mode
Inverter overheated/Overload
Overvoltage/Undervoltage
Other fault
17
