Idiomas disponibles
Idiomas disponibles
06
To replace the printer roll, it is necessary to open the door on the autoclave front panel,
insert a roll of thermal paper (whose maximum width must be of 57 mm) in the suitable
place making the paper come out from the door while it is closed.
After the sterilisation cycle, the autoclave finishes to print the convalidation ticket; after
printing, cut the ticket by pulling it upwards. The cutter built in the printer will cut the ticket.
Pay attention to the thermal paper orientation sense; it can be printed only on one side.
For a correct and long storage of the sterilisation ticket, it is necessary to preserve
the same in a place protected by light and heat sources.
07
The installation is a fundamental operation for the following use and good operation of the
device.
Here is a list of the points to be followed in order to achieve a good installation.
1. The device must be installed inside a laboratory accessible only to authorised
personnel.
2. The room in which the autoclave is installed must comply with current work place
illumination regulations.
3. Position the device on a plane surface with minimum capacity 60 Kg.
4. Make sure that the sterilisation chamber is slightly tilted towards the bottom.
5. Leave at least 10 cm between the device rear part and the wall.
6. Position the autoclave at such a height as to make it possible for the operator to check
the whole sterilisation chamber and carry out the normal cleaning operations.
7. The room where the device is installed must be enough ventilated.
8. Do not install the autoclave near washing basins, taps, because the device furniture is
not waterproof.
9. Do not place trays, papers, fluid containers, etc. on the device, because the device grids
are used to ventilate must not be obstructed.
10. Do not lean on the door when it is opened.
11. Do not install the device near sources (for instance: autoclave, bunsen, burner and kiln);
keep a minimum distance of 40 cm.
12. Install the device in such a way as not excessively bend the supplying cable.
13. In case the filling tank is directly discharged in waste waters, position the device at a
height which is higher than the discharge.
REPLACING THE PRINTER ROLL
INSTALLATION
ENGLISH
7
