Idiomas disponibles
Idiomas disponibles
A
•
Turn the throttle control counterclockwise (A) to
increase the engine speed. The end position is the
full speed.
•
Turn the throttle control clockwise (B) to decrease
the engine speed. The end position is the idle speed.
To stop the product
1. Park the product in a safe area and on a level
To operate the product on page
surface. Refer to
11 .
2. Set the movement controls in neutral position.
3. Turn the ON/OFF key counterclockwise to the OFF
position.
4. Release the seat belt.
5. Remove the blade from the product.
To remove a soft floor surface
WARNING:
blades are very sharp.
Note:
Short blades cut the floors easier than long
blades. Long blades are not always better or faster. A
short blade usually cleans the floor better than a wide
blade.
Note:
The blades are sharp for a longer time if the
work area is clean from unwanted material.
1. Use personal protective equipment. Refer to
Personal protective equipment on page 7 .
2. Install a self scoring blade. Refer to
blade on page 16 and To replace the blade on
page 16 .
WARNING:
The blades are very sharp.
12
B
Use protective gloves. The
To replace the
Use protective gloves.
3. Make sure that the blade is sharp. Sharpen the
blade if it is necessary. Refer to
blade on page 16 .
4. Cut a linear ditch in the floor.
5. Install a flat blade.
WARNING:
The blades are very sharp.
6. Start at the ditch and remove the floor.
1
To remove a hard floor surface
WARNING:
blades are very sharp.
Note:
Short blades cut the floors easier than long
blades. Long blades are not always better or faster. A
short blade usually cleans the floor better than a wide
blade.
Note:
The blades are sharp for a longer time if the
work area is clean from unwanted material.
1. Use personal protective equipment. Refer to
Personal protective equipment on page 7 .
2. Install a short blade of the correct type. Refer to
replace the blade on page 16 and To replace the
blade on page 16 .
To sharpen the
Use protective gloves.
2
Use protective gloves. The
1998 - 001 - 03.07.2023
To
