Dometic MWE9104 Instrucciones De Montaje Y De Uso página 14

EN
Setting the STOP zone with the bike carrier connected (only MWE9104)
As soon as a ground signal is present at PIN 6 (see chapter
and the following settings apply:
• Function 60 is set to 00 (factory setting): The sensors are deactivated.
• Function 60 is set to 01: The STOP zone is adjusted as set in functions 61 and 62.
Note
• By factory setting, function 60 is set to 00, i.e. the sensors are automatically deactivated as soon as
a ground signal is present at the parking aid. A ground signal connection is established between
PIN 12 of the hook connector (13-pin according to ISO 11446) from the bike carrier and PIN 6 of the
parking aid. Use the yellow/blue (ye/bu) cable.
• Function 60 must be set to 01 for the settings of functions 61 and 62 to be activated.
1. Set function 61 to the required value for the STOP zone of the middle sensors.
2. Set function 62 to the required value for the STOP zone of the outer sensors.
3. Set function 60 to 01 to activate the set STOP zone settings.
Mirror function display
The orientation of the LED display (accessories) can be switched.
MWE9104: Set function 42 to the value 1 to switch the le display for the right display when using the LED
display (accessories).
MWE9104F: Set function 22 to the value 1 to switch the le display for the right display when using the LED
display (accessories).
Restoring the factory settings
1. Press and hold the right setting button for longer than 5 s to open the settings menu (see chapter
ues).
The diplay shows 01.
2. Press and hold both setting buttons for more than 2 s to reset all customized settings to factory settings (see
chapter Configuring the control
The display shows FS. The factory settings are restored.
14 Operation
Before first use
WARNING! Risk of injury
• Only test the device on stationary objects. Ensure that there are no persons in the vicinity outside the
vehicle.
• Familiarize yourself with the different tone sequences.
• Only test the device at walking speed.
Test the parking aid before first use. Drive slowly towards a stationary object, e.g. a wall.
14
PIN assignment of
module).
connector), function 60 is detected
Setting the val