Match The Collar Receiver And Remote Transmitter; Program The Collar Receiver For Two-Dog Operation - SportDOG SportTrainer SD-1825E Manual De Funcionamiento

6 Continuous
stimulation (Level set
by intensity dial)
7
Continuous
stimulation (Level set
by intensity dial)
8
N/A
NOTE: Modes 1, 3, 5 ,6 and 7 provide 8 levels of stimulation, which correspond to the setting of the
Intensity Dial.
Modes 2 and 4 provide more "increments" to choose from – a total of 16 levels of stimulation. For
example, in mode 2 with the Intensity Dial set at 2, the lower button provides level 3 of 16 and the
upper button provides level 4 of 16.
* For Two-Dog operation setup refer to Step 7 below.
** After selecting mode 2 and while the green indicator light is still solid in colour, turn the intensity
dial to the desired Continuous Stimulation level and press the side button to set the level. The
green light will quickly fl ash acknowledging your selection. For example, if you turned the intensity
dial to 3, the side button on your Remote Transmitter will transmit Continuous Stimulation at level 3
when pressed. If no level is selected after 15 seconds, it will default to level 8.
_____________________________________________________________________________

MATCH THE COLLAR RECEIVER AND REMOTE TRANSMITTER

To reset the Collar Receiver to work with a new Remote Transmitter or to reprogram a new Collar
Receiver to work with your existing Remote Transmitter:
A. Turn the Collar Receiver off.
B. Press and hold the On/Off Button. The Receiver Indicator Light will come on, then turn off after 5-6
seconds. If the On/Off Button is released too early, the Receiver Indicator Light will begin fl ashing as
normal. If this occurs, start over and repeat from A.
C. After the Receiver Indicator Light has turned off, release the On/Off Button.
D. Press and hold the Upper Button on the Remote Transmitter until the Receiver Indicator Light fl ashes 5
times. You may need to hold both units 60-90 cm (24"-36") from each other before this occurs. Once the
Receiver Indicator Light has fl ashed 5 times, the Collar Receiver has been reset and will begin fl ashing
as normal. If the Receiver Indicator Light does not fl ash 5 times, start over and repeat from A.
_____________________________________________________________________________

PROGRAM THE COLLAR RECEIVER FOR TWO-DOG OPERATION

™
SportDOG Collar Receivers can be set to respond to either the
UP or DOWN toggle switch position. A SportDOG
Collar Receiver must be purchased to train a second dog in two-
dog mode. Please refer to the Accessories section on page 14 for
compatible Add-A-Dog
1. Program the Remote Transmitter to mode 1, 4, 5, or 7 (see page 11).
2. Then fl ip the toggle switch to the UP (ORANGE) position to program
the fi rst Collar Receiver.
A. Turn the Collar Receiver off.
B. Press and hold the On/Off Button. The Receiver Indicator Light
will come on, then turn off in 4-5 seconds. If the On/Off Button is
released too early, the Receiver Indicator Light will begin its
normal fl ashing. If this occurs, start over and repeat from A.
Tone only
Vibration only
N/A
®
Collar Receivers for this system.
WWW.SPORTDOG.COM
Vibration only
N/A
N/A
TOGGLE SET TO UP (ORANGE)
™ ®
Add-A-Dog
TO DOWN (BLACK) FOR DOG 2
Dog 1 / 2
Dog 2*
Dog 1 / 2
Dog 2*
N/A N/A
FOR DOG 1 OR TOGGLE SET
13