TOGGLE SWITCH IN
TOGGLE SWITCH IN THE UP POSITION
MODE UPPER BUTTON
FUNCTION
1
Continuous stimulation
(Level set by intensity
dial)
2
Continuous stimulation
(Level set by intensity
dial)
3
Dog 1 (Level set by
intensity dial)
4
Continuous stimulation
(Level set by intensity
dial)
5
Continuous stimulation
(Level set by intensity
dial)
6
N/A
7
Continuous stimulation
followed by a ¼
second delay tone
(Level set by
intensity dial)
8 (ID
N/A
Code)
NOTE: Modes 1, 3, 4 ,5 and 7 provide 8 levels of stimulation, which correspond to the setting of the Intensity Dial.
Mode 2 provides more "increments" to choose from – a total of 16 levels of stimulation. For example, in
mode 2 with the Intensity Dial set at 2, the lower button provides level 3 of 16 and the upper button provides
level 4 of 16.
* For Two-Dog operation setup refer to Step 7 on page 13.
** An ID Code is the signal identifi cation between the Remote Transmitter and Collar Receiver. Each
is programed in 1 of 4,000 ID Codes from the factory. In the rare event that a Remote Transmitter is
sending a signal to more than one Collar Receiver, you can change the Remote Transmitter's ID
Code to prevent this from happening. There are 64 programmable ID Codes available.
THE UP POSITION
LOWER BUTTON
FUNCTION
Momentary stimulation
(Level set by intensity
dial)
Low continuous
stimulation (Level set by
intensity dial)
Dog 2 (Level set by
intensity dial)
Tone only
Momentary stimulation
(Level set by intensity
dial)
N/A
Momentary stimulation
followed by a ¼ second
delay tone (Level set by
intensity dial)
N/A
WWW.SPORTDOG.COM
THE DOWN POSITION
SIDE BUTTON
TOGGLE
FUNCTION
SWITCH
(up/down)
Tone only
Dog 1 /
Dog 2*
Tone only
Continuous/
Momentary
Dog 3 (Level
Continuous/
set by intensity
Momentary
dial)
N/A
Dog 1 /
Dog 2*
N/A
Dog 1 /
Dog 2*
N/A
N/A
Continuous
Dog 1 /
stimulation + 2
Dog 2*
See below**
Up position
TOGGLE SWITCH IN
NUMBER
OF DOGS
2
1
3
2
2
N/A
2
N/A
11