Hilti Nuron DSH 700-22 Manual De Instrucciones Original página 39

3. Slacken the nut on the dust extraction module until the housing parts can be opened as far as the end
stops on the connecting axle.
4. Engage the dust extraction module in the notches provided for the purpose in the blade guard.
▶ The notches slide smoothly into engagement without jamming.
5. Tighten the nut hand-tight.
6. Return the blade guard to the closed position.
7. Connect an industrial vacuum cleaner suitable for the application to the dust extraction module.
5.8.2 Removing dust extraction module (accessory)
1. Move the blade guard until the installation position of the dust extraction module is freely accessible.
2. Slacken the nut on the dust extraction module.
3. Disengage the dust extraction module from the blade guard.
4. Return the blade guard to the closed position.
6 Operation
Unless otherwise stated, the descriptions below are applicable for DSH 600-22 and DSH 700-22.
6.1 Cutting techniques
Avoiding kickback
There is a risk of kickback if the cut-off saw comes into contact with the working surface in the area indicated.
▶ Avoid bringing the cut-off saw into contact with the working surface in the area indicated.
▶ Always bring the cut-off wheel into contact with the workpiece from above. Allow the cut-off wheel to
contact the workpiece only at a point below its rotational axis.
▶ Take special care when inserting the cut-off wheel in an existing kerf.
*2284136*
2284136 English 33