Idiomas disponibles
Idiomas disponibles
5.5
Removing the cut-off wheel
WARNING
Risk of injury and damage. Damaged cut-off wheels may break.
▶ If the cut-off wheel has been subjected to an impact, check the disc for damage and replace it if
necessary.
▶ Never use cut-off wheels that are damaged, run untrue or vibrate.
▶ Don't use synthetic resin-bonded fiber-reinforced cut-off wheels which have exceeded their use-by date
or already softened due to water absorption.
1. Remove a mounted dust extraction module (accessory). → page 33
2. Insert the locking pin into the hole in the belt cover.
3. Gently turn the cut-off wheel until the locking pin engages.
4. Slacken the securing screw with the assembly tool.
5. Remove the securing screw, clamping flange and cut-off wheel.
6. Remove the locking pin.
5.6
Adjusting the guard
WARNING
Risk of injury. Contact with the cut-off wheel, flying fragments or sparks can cause injury to persons.
▶ Adjust the guard so that flying particles or fragments of the material removed and flying sparks are
directed away from the operator and the product.
▶ Hold the guard by the grip provided and rotate it to the desired position.
5.7
Installing cut-off saw on saw trolley (accessory)
DSH 700-22
Before starting installation of the power tool on the saw trolley, install the wheel set (accessory).
1. Remove the water tank from the saw trolley.
2. Move the cutting depth adjustment lever into the upper position.
3. Open the hold-down device by releasing the screw knob.
4. Set the cut-off saw with the wheels in front mount (1) and swivel the grip of the cut-off saw underneath
hold-down device (2) .
5. Secure the cut-off saw by tightening screw knob (3) .
6. Secure the throttle cable to control switch (4) .
7. Fit the water tank after filling it.
8. Connect the water hose to the cut-off saw by means of a Gardena coupler.
9. Adjust the grip to a convenient working height.
10. Adjust the guard to the correct position. → page 32
5.8
Preparations for dust extraction module
5.8.1
Installing dust extraction module (accessory)
Used in combination with an industrial vacuum cleaner, the dust extraction module reduces the amount of dust
created by dry-cutting operations. Use the dust extraction module only for dry-cutting in mineral materials.
The severe heat produced by cutting in metals or use for wet cutting will destroy the dust extraction module.
Read and observe the instructions on safety and use in the operating instructions of the accessory.
1. Clean the blade guard and the notches for installation of the dust extraction module.
2. Move the blade guard until the installation position of the dust extraction module is freely accessible.
32
English
2
4
5
2284136
*2284136*
