Idiomas disponibles
Idiomas disponibles
•
Avoid unnecessary exposure of the battery to dust and dirt. Never expose the battery to high levels of
moisture (e.g. by being dipped in water or left in the rain).
If a battery has been soaked by moisture, treat it as a damaged battery. Isolate it in a non-flammable
container and consult Hilti Service.
•
Keep the battery free of extraneous oil and grease. Do not permit dust or dirt to accumulate unnecessarily
on the battery. Clean the battery with a dry, soft brush or a clean, dry cloth. Do not use cleaning agents
containing silicone as these can attack the plastic parts.
Do not touch the contacts of the battery and do not remove the factory-applied grease from the contacts.
•
Use only a slightly damp cloth to clean the housing. Do not use cleaning agents containing silicone as
these can attack the plastic parts.
Maintenance
•
Check all visible parts and controls for signs of damage at regular intervals and make sure that they all
function correctly.
•
Do not use the product if signs of damage are found or if parts malfunction. Immediately have the product
repaired by Hilti Service.
•
After cleaning and maintenance, install all guards and protective devices and check that they are in full
working order.
To help ensure safe and reliable operation, use only genuine Hilti spare parts and consumables. Spare
parts, consumables and accessories approved by Hilti for use with your product can be found at your
Hilti Store or online at: www.hilti.group
7.1
Cleaning the guard
1. Remove the saw blade. → page 27
2. Clean the parts of the guard carefully with a dry brush.
3. Use a suitable tool to remove deposits or cuttings from the inside surfaces of the parts of the guard.
4. Install the saw blade. → page 28
7.2
Emptying chip collector / cleaning chip ejector channel
The chip ejector channel carries dust and chips away from inside the top guard. If the chip ejector channel
is clogged dust and chips can no longer be carried away correctly. Clean the chip ejector channel at regular
intervals to extend the service life of the product.
Emptying chip collector
CAUTION
Risk of injury Hazard due to hot or sharp chips or hot chip collector!
▶ Always install the chip collector when you are going to cut metals.
▶ Always wear protective gloves when emptying or removing the chip collector.
1. Open the flap of the chip collector.
2. Empty the chips from the chip collector into a suitable waste receptacle.
3. Close the flap of the chip collector.
Cleaning chip ejector channel
4. Remove the saw blade. → page 27
5. Pull the chip collector up out of the guides.
6. Clean the chip ejector channel with a brush.
7. Install the saw blade. → page 28
Installing chip collector
8. Insert the chip collector with the bottom clamps in the guides.
9. Press the chip collector at the top slightly toward the guard and push the chip collector down.
▶ The chip collector engages with an audible click.
7.3
Checks after cleaning and maintenance
After cleaning or maintenance, check that all safety devices are fitted and that they function faultlessly.
1. To check the pivoting guard, open the guard fully by moving the guard operating lever.
▶ The pivoting guard must close quickly and completely when the guard operating lever is released.
30
English
9
2360040
*2360040*
