Hilti Nuron SC 6ML-22 Manual De Instrucciones Original página 34

Ocultar thumbs Ver también para Nuron SC 6ML-22:
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 71
3. Remove the clamping screw and the clamping flange (3).
4. Open the pivoting guard (4) and remove the saw blade (5).
If necessary, the mounting flange can be removed for cleaning.
5.6
Installing the saw blade
Check that the blade to be fitted complies with the technical requirements and that it is well sharpened.
A sharp saw blade is an essential requirement for a perfect cut.
1. Clean the mounting flange and the clamping flange.
2. Slip the mounting flange right way round on to the arbor (1).
3. Open the pivoting guard (2).
4. Insert the new saw blade.
Note the direction-of-rotation arrows (3) on the saw blade and on the product. They must point in
the same direction.
5. Place the outer clamping flange in position, right way round (4).
6. Install the clamping screw.
7. Insert the hex key into the saw blade clamping screw.
8. Press and hold down the spindle lock button (5).
9. Use the hex key to tighten the clamping screw (6).
10. Check that the saw blade is seated correctly.
11. Insert the hex key into the hole provided for the purpose.
5.7
Adjusting the cutting depth
1. Release the cutting depth adjustment clamping lever (1).
2. Lift the product in a scissoring movement and set the cutting depth (2).
3. Tighten the cutting depth adjustment clamping lever (3).
The cutting depth should always be set to a depth approx. 5 to 10 mm greater than the thickness
of the material to be cut.
5.8
Installing fence
1. Squeeze the wings of the clamp together.
2. Push the fence into the base plate.
▶ You can adjust the cutting width to suit your application.
3. Release the wings of the clamp.
▶ The fence is fixed in position.
When you want to adjust the fence, squeeze the wings of the clamp together.
5.9
Installing pipe-cutting adapter (accessory)
1. Remove installed accessories.
2. Hook the base plate into the front mounts of the pipe adapter.
3. Push the base plate into the rear mounts of the pipe-cutting adapter.
▶ The base plate engages.
4. Adjust the pipe-cutting adapter to the diameter of the pipe.
6
Operation
Observe the safety instructions and warnings in this documentation and on the product.
28
English
4
5
6
2360040
*2360040*
loading