Idiomas disponibles
Idiomas disponibles
INPUT AND OUTPUT SELECTION
No.
Item
Optional function
149
Not used
S8
?
N O T E
•
After at least three minutes from power ON, change the optional setting.
•
When changing the "CF" setting (change of louver swing angle), restore the power supply or allow the louver to make one complete swing fully in
the auto-swing mode to apply the optional setting.
•
The optional settings may be different according to the indoor and outdoor unit models. Check to ensure that the unit has the optional setting.
•
Record the setting conditions for each optional setting in the "Setting" column of the table below.
•
The above optional functions marked with an "X" at the individual setting can change the condition only when "All Rooms" is set.
8 INPUT AND OUTPUT SELECTION
1 Press and hold " " for "Temp" and "Fan" simultaneously for
at least three seconds during the normal mode (when unit is
not operated).
2 Select the optional mode by pressing " " or " " for "Temp"
and press "Fan".
01: Function
Selection
02: Input/Output
Setting
3 Select the indoor unit by pressing " " or " " for "Temp" and
press "Fan".
(This screen is NOT displayed when there is only one indoor
unit connected with the controller.
In this case, (4) will be displayed.)
22
PMML0497 rev.1 - 12/2020
Individual
Settings
Setting
00
01
02
03
04
05
06
07
-
08
09
10
11
12
13
14
15
4 Press " " or " " for "Temp" and select the item.
5
6 Press " " and " " for "Temp" simultaneously to return to the
Setting conditions
Press "Fan" and change the setting.
normal mode.
Description
Use at 00 conditions
