Idiomas disponibles
Idiomas disponibles
English
(spindle facing user) but self-locks in the counter-
clockwise direction.
•
Two-touch
TM
: In this position the engaging face is
straight and squared off. It will NOT ride over to the next
alignment hole unless guard release lever is pressed and
held while simultaneously rotating the guard in either
a clockwise or counter-clockwise direction (spindle
facing user).
One-Touch
TM
Fig. C
26
setting guard Adjustment Options
To adjust the guard release lever
adjustment option:
1. Remove screw
18
using a T20 bit.
2. Remove the guard release lever taking note of the
spring position. Choose the end of the lever for the
desired adjustment option. One-touch will use the
slanted end of the lever
7
holes
on the guard collar. Two-touch will use the
14
squared end to engage the alignment holes
guard collar.
3. Replace the lever, positioning the chosen end under the
spring
26
. Ensure the lever is in proper contact with
the spring.
4. Replace screw and torque to 2.0-3.0N-m. Ensure proper
installation with spring return function by depressing
guard release lever
7
.
Mounting guard (Fig. D)
CAUTION: Prior to mounting guard, ensure the screw,
lever, and spring are fitted correctly before mounting
the guard.
1. With the spindle facing the operator, press and hold the
guard release lever
.
7
8
Two-Touch
TM
18
7
for desired
7
to engage the alignment
14
on the
2. Align the lugs
15
on the guard with the slots
the gear case cover.
3. Push the guard down until the guard lugs engage
and rotate them in the groove on the gear case cover.
Release the guard release lever.
4. To position the guard:
One-touch
TM
: Rotate the guard clockwise into the
desired working position. Press and hold the guard
release lever
7
to rotate the guard in the counter-
clockwise direction.
Two-touch
: Press and hold the guard release
TM
lever
. Rotate the guard clockwise or counter-
7
clockwise into the desired working position.
nOTE: The guard body should be positioned between
the spindle and the operator to provide maximum
operator protection.
The guard release lever should snap into one of the
alignment holes
on the guard collar. This ensures
14
that the guard is secure.
5. To remove the guard, follow steps 1–3 of these
instructions in reverse.
Fig. D
15
16
Flanges and Wheels
CAUTION: Turn unit off and unplug the tool before
making any adjustments or removing or installing
attachments or accessories.
Mounting Non-Hubbed Wheels (Fig. E)
WARNING: Failure to properly seat the flanges and/or
wheel could result in serious injury (or damage to the
tool or wheel).
CAUTION: Included flanges must be used with
depressed center Type 27/42 grinding wheels and
Type 1/41 cutting wheels. Refer to the Accessories
Chart for more information.
WARNING: A closed, two-sided cutting wheel guard
is required when using abrasive cutting wheels or
diamond coated cutting wheels.
WARNING: Use of a damaged flange or guard or fail-
ure to use proper flange and guard can re sult in injury
due to wheel breakage and wheel contact. Refer to
the Accessories Chart for more information.
1. Place the tool on a table, guard up.
16
on
14
7
