Idiomas disponibles
Idiomas disponibles
10
Premier Ductable Heater
Gas Supply Sizing
The vaporization of propane is affected by several
factors: the surface area of the container, the liquid level
of propane, temperature surrounding the container, and
the relative humidity. All of these factors are specific to a
site. Therefore, a degree of experience and judgement is
required to select the proper propane supply.
Although experience is the best guide, the following
recommendations can be used as a starting point. The
table is based on experience in northern climates where
cold weather and high humidity are prevalent in the
winter. If more or less favorable conditions prevail at a
specific site, adjustments can be made on the basis of
experience.
Recommended Gas Supply
TANK SIZE
500 gal. / 1892 litre
1000 gal. / 3784 litre
If more than one gas supply container is used per heater,
the containers must be manifolded together to allow
vapor withdrawal simultaneously from multiple containers.
Manifold system shall be in accordance with NFPA 58 or
CSA B149.1.
Gas Hose and Regulator
(Optional accessories )
Gas Hose:
1 in. x 15 ft. (2.5 cm x 4.6 m): 500-132047
NOTE: The gas hose and regulator are not shipped with
the heater. They are optional accessory and must
be ordered separately.
Gas Hose
1. The heater has a 1 in. (2.5 cm) NPT pipe nipple at the
gas inlet of the heater. See Fig. 1.
2. With the appropriate connection, attach the hose fitting
and hose to the pipe. Tighten securely.
3. Leak check the connection with an approved leak
detector.
Owner's Manual • Premier Ductable Heater
FIG. 1
HEATERS / TANK
1
Regulator
2
WHEN USING PROPANE GAS: 500-25141
1. Lift the tank's cover.
2. Assemble the gas component as shown, depending on
FIG. 2
3. Form the pigtail connector, supplied with regulator kit
4. Thread connector's POL fitting courter-clockwise into
5. Open the tank valve slowly.
6. Check all connections with an approved leak detector.
heater type. Tighten connections securely. See Fig. 2.
REDUCING
BUSHING
500-25141, to ensure the regulator will be supported
by the tank, and the tank valve cover will protect the
regulator from weather conditions.
the tank valve. See FIG. 2.
Close the tank's cover.
1 IN. NPT PIPE
TANK VALVE
1/4 IN.
POL
NPT
PIGTAIL CONNECTOR
