Assembly Instructions; Fitting Instructions - Altrad Belle PCX 450 Manual Del Operador

Assembly Instructions for Vibrator
1. Clean out Housing (9) with gun wash then
blow dry with compressed air.
2. Fit rear Bearing (3a) into Housing and push
Shaft (8) into Bearing.
3. Fit front Bearing (3b) onto Shaft and into
Housing.
4. Fit Bearing Cover 'B' (10) c/w Gasket (4a) to
the rear of the Housing.
5. Fit Oil Seal (6) into Bearing Cover 'A' (7).
6. Fit Bearing Cover 'A' c/w Gasket (4b) to the
front of the Housing.
7. Fit Woodruff Key (11) and Pulley (12) onto
Shaft.
8. Pour oil into oil drain hole in the housing
until oil just starts to trickle out.
9. Fit Copper Washer (2) and Oil Drain Plug (1).
10. Fit Vibrator onto Baseplate and tighten bolts
to a torque of 150Nm.
11. Run for approximately 2 minutes to ensure
oil does not leak from the Vibrator.
Paving Pad
The paving pad has been designed to be used
when tamping down paving slabs and block
pavers. However, it should not be used for
normal compaction work.
Before tting, make sure the paving pad you
have is the correct size and the correct type
(HAUC 'Dual Force' or standard).
To t the Paving Pad (1), place the pad under
the plate ensuring the securing holes line up with
the holes on the front of the baseplate.
The securing coach bolts (4) should be passed
through the clamp strip (5) then the paving pad
(1) and nally through the baseplate. They are in
turn secured in place with the nut (2) and washer
(3).
Transporter Attachment
The transporter attachment enables the operator to move the compactor to the work place with the minimum of effort.
Removable Transporter Attachment
To t the transport attachment, align the pivot bracket with the holes on the rear of the baseplate.
The two securing bolts should be passed through the pivot bracket and the baseplate. They are in turn secured in place with the
Nyloc nut and washer.
Slide the wheel frame onto the pivot bracket, tilt the compactor forward then swing the wheel frame forward and under. Finally, tilt the
compactor back and onto the wheels.
Fixed Transporter Attachment
To t the transport attachment, align the bracket with the holes on the rear of the bedplate. The two securing bolts should be passed
through the bracket and into the bedplate.

Assembly Instructions

10
4a
3a
1
2
9

Fitting Instructions

3
4
5
15
12
8
3b
4b
2
GB
11
7
6
5
GB
1