Idiomas disponibles
Idiomas disponibles
USING ACCESSORIES
The chart below lists the description, use speed and scope for some of the small articles supplied together with the tool by
category. To achieve best performance of the tool, it is strongly recommended that you read it prior to operation, failure to
adhere to this may cause accessories to fail.
NOTE: ALWAYS Wear eye protection Insert the shaft FULLY into the collet. Use ONLY up to the speeds stated below.
PICTURE
20
DESCRIPTION
Grinder bits
Various head styles,
on shafts
Diamond Bits
Various head styles
Wool Wheel
Mounted to screw drill
Sanding/Cutting wheels
Mounted to cutting wheel fixture
NOTE: DO NOT over tighten screw
Sanding Roll
Mounted on hold for rubber wheel
NOTE: To fit the sanding roll, firstly loosen the small screw on top of the hole for rubber wheel,
this will allow the rubber to relax. Slide the sanding roll onto the holder.
To secure, simply tighten the screw and the rubber roll will swell, gripping the sanding drum.
SPEED
Full speed
Full speed
Half speed
Half speed
Full speed
FOR USE ON:
Metal
Mild steel
Wood Zinc
Plastic Nickel
Copper Mild steel
Metal
Mild steel
Metal
Mild steel
Wood
Metal
Mild steel
EN
