Idiomas disponibles
Idiomas disponibles
Additional safety instructions for grinding
and cutting-off operations
Safety warnings specific for grinding and
abrasive cutting-off operations:
a) Use only wheel types that are
recommended for your power tool and
only for recommended applications.
For example: do not grind with the side
of a cut-off wheel. Abrasive cut-off wheels are
intended for peripheral grinding, side forces applied to
these wheels may cause them to shatter.
b) For threaded abrasive cones and plugs
use only undamaged wheel mandrels
with an unrelieved shoulder flange that
are of correct size and length. Proper
mandrels will reduce the possibility of breakage.
c) Do not "jam" a cut-off wheel or apply
excessive pressure. Do not attempt to make
an excessive depth of cut. Overstressing the wheel
increases the loading and susceptibility to twisting or
snagging of the wheel in the cut and the possibility of
kickback or wheel breakage.
d) Do not position your hand in line with and
behind the rotating wheel. When the wheel, at
the point of operation, is moving away from your hand,
the possible kickback may propel the spinning wheel
and the power tool directly at you.
e) When wheel is pinched, snagged or when
interrupting a cut for any reason, switch
off the power tool and hold the power
tool motionless until the wheel comes
to a complete stop. Never attempt to remove
the cut-off wheel from the cut while the wheel is in
motion otherwise kickback may occur. Investigate and
take corrective action to eliminate the cause of wheel
pinching or snagging.
f)
Do not restart the cutting operation in
the workpiece. Let the wheel reach full
speed and carefully re-enter the cut. The
wheel may bind, walk up or kickback if the power tool
is restarted in the workpiece.
g) Support panels or any oversized
workpiece to minimize the risk of wheel
pinching and kickback. Large workpieces
tend to sag under their own weight. Supports must be
placed under the workpiece near the line of cut and
near the edge of the workpiece on both sides of the
wheel.
h) Use extra caution when making a
"pocket cut" into existing walls or other
blind areas. The protruding wheel may cut gas or
water pipes, electrical wiring or objects that can cause
kickback.
18
Additional safety instructions for wire
brushing operations
Safety warnings specific for wire brushing
operations:
a) Be aware that wire bristles are thrown by
the brush even during ordinary operation.
Do not overstress the wires by applying excessive load
to the brush. The wire bristles can easily penetrate
light clothing and/or skin.
b) Allow brushes to run at operating speed
for at least one minute before using
them. During this time no one is to stand in front or
in line with the brush. Loose bristles or wires will be
discharged during the run-in time.
c) Direct the discharge of the spinning wire
brush away from you. Small particles and tiny
wire fragments may be discharged at high velocity
during the use of these brushes and may become
imbedded in your skin.
SYMBOLS
To reduce the risk of injury, user must
read instruction manual
Double insulation
Warning
Wear ear protection
Wear eye protection
Wear dust mask
EN
