TRAPP TRF 50 Manual De Instrucciones página 45

www.trapp.com.br
To operate with dry products (grains):
Fit the cover plate (1), according to figure 1. Except

for models TRF 50 and TRF 70.
Mount the green crop funnel cover (5) according to

figure 1.
Choose the appropriate sieve, according to the

material intended to be produced, (diameters 0.8 -
3 - 5 - 12 mm), because the resulting product
depends on the used sieve diameter. See the
application table for each equipment.
The dry product is placed in the grain funnel (2), from

where it is directed to be processed, the final product
being poured in the material output funnel (6). Place
a container or a raffia bag under the material output
funnel (6) in order to collect the crushed material,
according to figure 1. In some models of shredders
the material will get out from the machine through
the lower part of the shredder body (7), and a
container or a raffia bag can also be used to collect
the crushed material, according to figure 2.
The TRAPP shredders are provided with a support

to fit a raffia bag or another type of container in
order to facilitate the crushed material collection, as
indicated (8), according to figures 1 and 2.
Be careful not to overload the motor. Regulate the

grain output adjuster according to the shredder's
capacity to grind and to the strainer chosen. The
regulation of the grain saída adjuster is done in
the following way: loosen the wing nut (3) located
underneath the grain output adjuster. Once the
regulator (4) is free, pull in case you need a bigger
opening, and push in case you need a smaller
opening. After regulating, tighten the wing nut (3),
according to figures 1 and 2.
The lower the sieve mesh, the lesser the amount of

material released by the grain funnel so as not to
overload the machine.
To Crush Grains
2
Fig. 1
Fig. 2
9
1
8
Merely illustrative image
7
3
4
5
6
4
3
8
45