Idiomas disponibles
Idiomas disponibles
Remove power to the pump, so that the engine can't start accidentally.
DISASSEMBLY
•
Remove the transparent protection cover through the 2 screws.
•
Position the impeller with the 2 white rollers in a vertical position.
•
Remove from its seat the ring on the left and then pull the pipe upward.
•
Manually rotate the rotor clockwise in order to pull up even the connection put at the right
of the pump.
ASSEMBLY
•
Position the impeller with the 2 white rollers in a horizontal position.
•
Press the pipe into his place, following gradually the path.
•
Remove from its seat the ring on the left and then pull the pipe upward.
•
Manually rotate the rotor clockwise in order to enter also the right connection of the pump.
•
Enter again the transparent protection cover, pressing it to its place and tighting the 2
screws.
8
• Carry out a visual check to verify the correct installation or any possible leak.
• Run at least a loop to test the success of the operation.
• If necessary execute an electrical test (EN 61010)
REPLACEMENT OF PUMP PIPE
TESTING PROCEDURE
At the end of any assistance service is a good rule:
ENGLISH
41
