Removing And Installing Blades - Bosch GCM18V-07S Instrucciones De Funcionamiento Y Seguridad

Removing and Installing Blades

Always wear gloves when changing or handling
blades. Blade tips can cause personal injury.
Removing Blade
1. Position the saw in the UP position and at 0°
bevel. If in the DOWN position: while press-
ing down slightly on the saw head assembly,
and pull out the head assembly lock pin (Fig.
8, 35). Then slowly allow the saw head as-
sembly to come up.
2. Rotate the Lower Blade Guard (Fig. 9, 22)
until there is clear access to the Blade Bolt.
Fig. 9
5
3. Press and hold the arbor lock (the red but-
ton on the opposite side of the upper guard
(23). Rotate the blade (21) slowly while
pressing the arbor lock until it fully seats
into its lock position.
4. Using the Torx wrench (Fig. 7, 39), loosen
the blade bolt by firmly turning it clockwise.
NOTE: This bolt has left-hand threads.
5. Remove the blade bolt and outer washer.
Carefully grab the blade. Slide the blade
(Fig. 10, 21) away from the inner washer
and off the arbor shaft, then down and away
from the saw. Leave the inner washer on the
arbor shaft.
16099221PK GCM18V-07S OSI 20220506.indd 19
Assembly
Fig. 10
Installing 7-1/4" (184mm) Blade
7-1/4" (184mm) diameter and 5/8" (15.88 mm)
arbor. The blade's maximum plate thickness is
22
5/64" (2 mm). The blade's maximum kerf thick-
ness is 1/8" (3.175mm).
23
Blade
(RPM) or greater.
bolt
not interfere with the table insert at 0° and 45°
21
bevel positions. Lower the blade into the blade
slot and check for any contact with the base or
turntable structure. If the blade contacts base
or table, seek authorized service.
1. If a blade is currently installed, remove it
2. Carefully handle the new blade. Check that
3. Place the outer washer over the arbor shaft
4. Rotate the blade slowly while pressing the
5. Using the Torx wrench (Fig. 7, 39), firmly
-19-
Outer
washer
Blade
bolt
To avoid injury, do not use a
blade larger or smaller than
To reduce risk of injury, use
saw blade rated 5000/min
After installing a new blade,
make sure the blade does
as described in "Removing Blade" on page
19.
the rotation arrow on the blade matches the
rotation arrow on the upper guard. Slide the
blade up and between the sides of the chip
deflector and over the arbor shaft. Move the
blade so its arbor hole goes around the sup-
port ring of the inner washer (Fig. 9 and Fig.
10).
and finger-tighten the blade bolt (counter-
clockwise). Check that the blade remained
on the inner washer's support ring.
arbor lock until it fully seats into its lock po-
sition.
tighten the blade bolt counterclockwise.
21
Arbor shaft
5/6/22 11:27 AM