Pride Mobility FUSION e Manual Del Propietário página 13

(6) Take out the pedals, install them and tie the leggings (8-4)
(7) Remove the handrail, install the left and right handrails, and use the Allen key
(included) tool to tighten the headless screws under the armrests. (8-7)
(8) Insert the rear tube of the controller into the right-hand tube (left) and adjust it to
the appropriate position (8-5); tighten the fastening bolts, connect the harness
connector of the upper control handle to the main connector, and turn on the
power supply to test whether the power chair powers up (8-6).
ADJUSTMENT
(1) Controller self-locking
1. Turn on the power, holding the power button for more than 2 seconds until you
hear a beep sound, then release;
2. Push the direction handle to the forward direction for more than 2 seconds until
you hear the beep;
3. Then push the direction handle back in the backward direction for more than 3
seconds until you hear the beep;
4. At this point, the power chair will not be able to operate.
(2) Controller unlock
1. Press the power button, when the speed light flash continuously, then release
the button.
2. Then push the direction handle to the forward direction for more than 2 seconds
until to hear the beep sound;
3. Finally, push the direction handle back in the backward direction for more than 2 seconds until to hear the sound of the beep;
At this point, the power status light will be turned on and you can operate your power
chair.
(3) Brake handle
The brake handles of the power chair are paired and are located behind the drive
wheel;
When the brake handle is disconnected the chair may be pushed forward (8-8).
When push up the brake handle, the motor will be in a snap-in state, then you can
drive the chair by using the joystick controller handle (8-9). This safety feature
prevents your power chair from moving while parked
Fusione
8-9
.
8-8
- 12 -