B - Replacement Of Batteries; C - Location Of The Remote Control; Use Of The Appliance; A - Preliminary Operations - Olimpia splendid DOLCECLIMA BREZZA Instrucciones Para El Uso Y El Mantenimiento

3.3.b - Replacement of batteries

Always use new batteries.
The use of old or different batteries could generate malfunctioning of the remote
control.
The remote control uses two dry alkaline 1.5V batteries (AAA.) (Fig.14).
When replacing batteries, replace both and dispose of the dead batteries in the appro-
priate collection centres and as required by law.
• If the remote control is not used for several weeks or longer, remove the batteries.
Any leaks from the batteries could damage the remote control.
Do not re-charge or disassemble the batteries. Do not throw the batteries into the fire.
They can burn and explode.
If the battery liquid falls onto the skin or clothes, wash well with clean water. Do not
use the remote control with batteries that have leaked.
The chemical products contained in the batteries can cause burns or other risks to
health.

3.3.c - Location of the remote control

• Keep the remote control in a position from which
the signal can reach the receiver (29) of the appli-
ance (maximum distance is approx. 5 metres - with
charged batteries) (figure D).
The presence of obstacles (furniture, curtains, walls,
etc.) between the remote control and the appliance
reduces the remote control range.

3.4 - USE OF THE APPLIANCE

Work as follows in order to use the appliance.
To prevent possible damages to the compressor, each start is delayed by 3 minutes with
respect to the last switching off.

3.4.a - Preliminary operations

• Place the appliance on a stable and not inclined base, at at least 50 cm. from the wall
or from any other object, in order to ensure the correct air circulation. Place it on a
water-resistant surface since the possible water leakage could damage furniture or
the floor.
• Do not place the appliance directly on carpets, towels, blankets or other absorbent
surfaces.
• Insert the plug in the power socket; the appliance emits a "beep" and all the LEDs
switch on for a few seconds, the appliance switches to stand-by mode.
Before electrically connecting the appliance, make sure the plate data correspond to
those of the electricity distribution network.
D
~5m
29
DOLCECLIMA BREZZA
EN - 15