It should be handled with care and in particular:
• Keep it dry (do not clean it with water or leave it
outdoors in bad weather).
• Avoid dropping or bumping it.
• Keep it out of direct sunlight.
• The remote control operates by means of an infrared beam.
• During use, there must not be any obstacle between the remote
control and the air-conditioner.
• If other appliances in the room have remote controls (TV, stereo,
etc...), there may be interference with consequent loss of the
sent signal.
• Electronic and fluorescent lights may also interfere with trans-
missions between remote control and air-conditioner.
• Remove the batteries in case of prolonged disuse of the remote
control.
• The remote control display goes off after a few seconds of non-
use, to reactivate it press any key.
3.3.1 - I nsertion of batteries (fig. 31)
To insert the batteries correctly:
a. Remove the batteries compartment cover.
b. Insert the batteries into the relevant compartment.
Check the polarity indicated on the bottom of the compartment.
c. Close the compartment correctly.
3.3.2 - Replacement of batteries
The batteries should be replaced when the display on
the remote control does not appear sharply or when
the remote control does not change the settings.
Always use new batteries and replace
both at the same time.
The use of old or different batteries could
generate malfunctioning of the remote
control.
The remote control uses two dry alkaline 1.5V batteries
(AAA.LR03) (fig. 31).
EN - 24
31