Steinberg Systems SBS-LHM-5000 Manual De Instrucciones página 31

Caution: The appliance will heat up to the last temperature setting entered if a new
value is not set.
(c) Press the "SET" key [E]. The last digit to the right begins to flash in the SV field.
(d) Press the "+" or "-" [H or G] key to reduce or increase the target temperature. You
can navigate to each digit to be modified by pressing "R/AT" [F].
(e) Store the temperature setting by pressing the "SET" key [E].
Auto calibration
(a) Turn off the appliance with the power I/O switch [4] if the actual temperature, PV,
increases above the temperature setting, SV.
(b) Wait for the appliance to cool down to ambient temperature.
(c) Press and hold the "R/AT" key [F] for 8 seconds.
(d) The auto calibration is finished when the SV field stops flashing and the actual
temperature, PV, is equal to the temperature setting, SV.
Setting the stirring speed
The maximum possible stirring speed setting of this appliance is more
Caution:
than 1,800 rpm. Do not exceed this limit!
The stirring speed setting and control varies between the heating mode on and off
status.
The appliance has the heating mode on:
a) Press the stirring on/off switch [I]. The R/MIN field [D] displays the stirrer
rpm.
b) Press the "SET" key [E]. The last digit in the SV field can now be edited (it is
flashing).
c) Press the "SET" key [E] again. The R/MIN field [D] displays the stirring speed
setting and last digit in the field can now be edited (it is flashing).
d) Press the "+" or "-" [H or G] key to reduce or increase the stirring speed
setting. You can navigate to each digit to be modified by pressing "R/AT" [F].
e) Press the "SET" key [E] to finish the stirring speed setting. The R/MIN field [D]
displays the actual stirrer rpm.
The appliance has the heating mode off:
a) Turn on the appliance with the power I/O switch [4].
b) Press the stirring on/off switch [I]. The R/MIN field [D] displays the actual
stirrer rpm.
c) Press the"SET" key [E]. The R/MIN field [D] displays the stirring speed setting
and last digit in the field can now be edited (it is flashing).
d) Press the "+" or "-" [H or G] key to reduce or increase the stirring speed
setting. You can navigate to each digit to be modified by pressing "R/AT" [F].
e) Press the"SET" key [E] to finish the stirring speed setting. The R/MIN field [D]
displays the actual stirrer rpm.