Idiomas disponibles
Idiomas disponibles
Make sure all electrical devices are switched off before
plugging them.
When connecting an equipment or extension cord to the AC
socket of the generator, you must ensure the following:
▪ The equipment and the extension cords are in good
condition. Defective equipment and extension cords can
cause electric shock;
▪ If an equipment starts operating abnormally, slows
down or stops suddenly, turn it off immediately;
▪ The power of the equipment may not exceed the capacity
of the generator. Never exceed the maximum power of
the generator. The maximum power of the generator may
not be used for a period longer than half an hour.
Exceeding the time limit on the maximum charge will
slowly overload the generator and even though you
do not switch off the circuit breaker, this process will
shorten the life of the generator.
Make sure the generator is connected to the ground
terminal. When the electrical device is grounded, the
generator must also be.
To connect the equipment to the generator, proceed as
follows:
1. Plug the generator;
2. Plug the ESC switch;
3. Connect the AC plug;
4. Make sure that the AC pilot light (3B) is switched on;
5. You can switch on the electrical device.
The ESC switch should be switched off to increase
engine speed to the correct rotations per minute. If
the generator is connected to several loads or electricity
consumers, remember to connect first the one with the
highest current and last the one with the lowest current.
1 - Engine switch/ fuel shut off valve is in
Engine switch/ fuel shut off valve is in "OFF" position.
Ignition system is off. Fuel circuit is off.
The mechanism will not work.
2 – Engine switch/ fuel shut off valve / Air intake shut-off
valves in
"ON" position;
Ignition system is on. Fuel circuit is on. Air intake shut-off
valves on.
The engine can start.
3 – Engine switch/ fuel shut off valve / Air intake shut-off
valves is in
"CHOCKE" position;
Ignition system is on. Fuel circuit is on. Air intake shut-off
valves off.
The engine can start.
You don't need to shut-off the air intake valve
start a hot engine.
When the oil level falls below the minimum level, the oil
alert indicator light (1B) lights up and the engine stops
automatically.
If the engine stops or does not start, set the switch to
the "ON" position and pull the recoil starter.
If the oil alert indicator light flashes or a few seconds, the
oil in the engine is insufficient. Add oil and start the engine.
"OFF" position;
to
