Assemble - HOLZMANN MASCHINEN BBS810SMART 400V Instrucciones De Servicio

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

14.2

Assemble

The sawhead is delivered pre-assembled, the following steps are necessary for assembling the
machine.
1.
Assembly the track ( general information)
Assemble the individual tracks and secure them loosely with the nuts and bolts provided. It is important
not to tighten the screws completely at this stage. This happens after the head has been mounted and
rolled along the track. It is recommended to assemble the track on a solid and flat surface. Attach the feet
at a height of about 10 cm.
Do not fully tighten the screws until the head has been assembly and saw head run is check.
Make sure the tracks run parallel and are already well leveled. Tighten the screws only
after sawhead assembly and controlling the running properties of the sawhead.
2. single steps for the assembly the track
21..levelling feet (12 pcs with 24 nuts)
22.. Main „L" channel left
23.. Main „L" channel right
32.. Externsion „L" channel left
33.. Externsion „L" channel right
HOLZMANN Maschinen GmbH
www.holzmann-maschinen.at
NOTICE
Assembly feet
Assembly 3 levelling feet per track part
(22,23,22a and 23a). To do this, unscrew
the lower nut to almost the same
height on all feet (21), unscrew the
upper nut and insert the threaded rod
into the hole in the track and then
secure it again using the upper nut.
Log support assembly onto the track
Assemble log support pieces (25, 26 and
32) as shown on the track be use of
screw and nuts (24).
Log clamps components (28, 40, 29 and
30a) are fastened to the tracks with
screws and nuts (24) as shown. The
clamps can be mounted at different
positions along the track. Make sure that
the log to be cut can always be securely
fixed.
Assembly the log support(s) (25, 26) on
the tracks (22a, 23a) as shown and fix
them with screws and nuts (24).
If another extension section
BBS550SMART_RB is used, only the log
support (25) at the end has to be
replaced by the log support (32) and the
extension rails have to be mounted with
ASSEMBLY
35
BBS810SMART_400V
Tabla de contenido
loading

Tabla de contenido