Safety Data
SEAL LUBE (P/N: PSA075508P)
LUBRIPLATE® 130-AA
Manufactured by:
Fiske Brothers Refi ning Co.
Phone: (419) 691-2491
Emergency: (800) 255-3924
ALVANIA® EP Grease 1
Prod Code: 71124
Manufactured by:
Shell Oil Products
Phone: (877) 276-7285
MSDS#: 57072E-5
First Aid:
SKIN:
Remove any contaminated clothing and wash with soap
and warm water. If injected by high pressure under skin,
regardless of the appearance of its size, contact a physician
IMMEDIATELY.
Delay may cause loss of aff ected part of body.
INGESTION:
Call a physician immediately. Do not induce vomiting.
EYES:
Flush with clear water for 15 minutes or until irritation
subsides. If irritation persists, consult a physician.
Fire:
FLASH POINT: COC- 400°F
Cool exposed containers with water.
Use foam, dry chemical, carbon dioxide or water spray.
Environment:
WASTE DISPOSAL:
Assure conformity with applicable disposal regulations.
Dispose of absorbed material at an approved waste disposal
facility or site.
SPILLAGE:
Scrape up grease, wash remainder with suitable petroleum
solvent or add absorbent.
Handling/ Storage:
Keep containers closed when not in use. Do not handle or
store near heat, sparks, fl ame or strong oxidants.
Lubriplate® is a registered trademark of Fiske Brothers
Refi ning Company.
Please refer to the actual MSDS for complete safety and
handling information. These can be obtained from the
point of purchase.
HYDRAULIC OIL (P/N: PRG540-130)
MOBIL DTE 26
Manufactured By:
ExxonMobil Corporation
Emergency Phone: (609) 737-4411
MSDS Fax on Demand:
(613) 228-1467 MSDS # 602649-00
Shell TELLUS 68
Manufactured By:
SOPUS Products
Health Information: (877) 504-9351
MSDS Assistance:
(877) 276-7285 MSDS # 402288L-0
Distributed By:
Emhart Teknologies
Phone: (203) 924-9341
First Aid:
SKIN:
Remove contaminated clothing and shoes and wipe excess
from skin. Flush skin with water, then wash with soap and
water. If irritation occurs, get medical attention.
INGESTION:
Do not induce vomiting. In general, no treatment is
necessary unless large quantities of product are ingested.
However, get medical attention.
EYES:
Flush with water. If irritation occurs, get medical attention.
Fire:
FLASH POINT: 390°F/198.9°C
Material will fl oat and can be re-ignited on the surface of
water. Use water fog, 'alcohol foam' , dry chemical or carbon
dioxide (CO2) to extinguish fl ames. Do not use a direct
stream of water.
Environment:
SPILLAGE:
Soak up residue with an absorbent such as clay, sand or
other suitable material. Place in a non-leaking container and
seal tightly for proper disposal.
Handling:
Wash with soap and water before eating, drinking, smoking,
applying cosmetics or using toilet. Properly
dispose of leather articles such as shoes or belts that cannot
be decontaminated. Use in a well ventilated area.
Storage:
Store in a cool, dry place with adequate ventilation. Keep
away from open fl ames and high temperatures.
E N G L I S H
27