Stanley PNT1000L-PC Manual De Instrucciones página 20

E N G L I S H
* Disengaging the tool from the insert
WARNING!
If you let go of the trigger during the installation sequence, the insert may not set completely, the hydraulics will reset and
the tool will not automatically unthread from the insert.
DO NOT pull the trigger again, follow the steps below to disengage the insert.
To disengage the tool from the insert and application:
1. Depress and hold the Control Knob
2. While holding the Control Knob, press and hold the trigger. This will cause the Mandrel to spin counter-clockwise and
unthread the insert.
3. When fully unthreaded, release the trigger.
To disengage the tool from the insert and work piece if the Mandrel is stuck:
1. Disconnect the air supply
2. Thread the M4 x20 Cap screw provided with the tool, into the hole in the side of the Nose Housing. Thread the Cap
screw in until if fi ts snugly against the inner Spin Pull Head, locking the rotatioin of the Mandrel to the tool.
3. Turn the body of the tool counter-clockwise to detach it from the insert.
2. trigger
1. Control Knob
20
Cap Screw
Nose Housing
Figure 12: Disengaging the tool from the insert
Измерване на кухина
Spin Pull Head
ROTATE