•
Have any damaged or defective part
repaired or replaced by an authorised
repair agent. Never attempt to remove or
replace any part yourself.
•
Before use, check the mains cable for wear
or damage.
•
Do not use the appliance if the mains cable
or mains plug is damaged or defective. If
the mains cable or mains plug is damaged
or defective, it must be replaced by the
manufacturer or an authorised repair agent.
Safety instructions for
breadmakers
•
Before use, always check that the mains
voltage is the same as the voltage on the
rating plate of the appliance.
•
Connect the appliance to an earthed wall
socket. If necessary, use an earthed
extension cable of a suitable diameter
(at least 3 x 1 mm
).
2
•
For additional protection, install a residual
current device (RCD) with a rated residual
operating current that does not exceed
30 mA.
•
The appliance is not intended to be
operated by means of an external timer or
separate remote-control system.
•
Make sure that water cannot enter the
contact plugs of the mains cable and the
extension cable.
•
Always fully unwind the mains cable and
the extension cable.
•
Do not use the appliance outdoors.
•
Do not use the appliance in humid
surroundings.
•
Make sure that the appliance does not
come into contact with flammable material.
•
Keep the appliance away from heat
sources.
•
Place the appliance on a stable and flat
surface.
•
Place the appliance on a heat-resistant
and splash-proof surface.
•
Do not place the appliance on a hob.
•
Make sure that there is sufficient space
around the appliance to allow heat to
escape and provide sufficient ventilation.
•
Do not cover the appliance. Do not place
oblects on top of the appliance.
•
Always be careful when touching the
appliance. Use oven gloves if you need to
touch the appliance during or shortly after
use.
•
The heating elements become very hot
during use. Do not touch the hot heating
elements.
•
Do not touch moving parts. Do not touch or
remove the bread pan while the appliance
is switched on.
•
Do not move the appliance while it is
switched on or is still hot. Remove the
mains plug from the wall socket and wait
until the appliance has cooled down.
•
Do not leave the appliance unattended
during use.
U.K. Wiring instructions Class 1
The wires in the mains lead are coloured in
accordance with the following code:
BLUE
NEUTRAL
BROWN
LIVE
GREEN/YELLOW
EARTH
As the colours of the wire in the mains lead of
this appliance may not correspond with the
colour markings identifying the terminals on
your plug, proceed as follows:
The wire which is coloured BLUE must be
connected to the terminal which is marked
with the letter N or coloured black.
The wire which is coloured BROWN must be
connected to the terminal which is marked
with the letter L or coloured red.
The wire which is coloured GREEN/YELLOW
must be connected to the terminal which is
marked with the letter E or (
coloured GREEN or GREEN/YELLOW.
If a 13Amp (BS1363) plug is used, a 13Amp
(BS1362) fuse must be fitted, or if any other
type of plug is used, a 13Amp fuse must be
fitted, either in the plug or adaptor, or on the
distribution board.
Warning! This appliance must be earthed.
15
) and is