Offset - Setting The Temperature; Revoke Key Lock; Offset - Make Setting; Activate Key Lock - Tecno-gaz TA009TAU Instrucciones De Uso

Offset – setting the temperature
4.2

Revoke key lock

4.2.1
Offset – Make setting
4.2.2

Activate key lock

4.2.3
9.696.160
TecnoSeal TA009TAU

Page 14
Chapter 4
1. Switch on the device
2. Check if the device is heating
3. Press and hold the two keys "Arrow down" &
"Menu" simultaneously.
4. Change level from COMPLETE to NONE.
5. Press the Menu/OK key
6. Controller unlocked
1. Press the Menu / OK  key
2. MENU level
Switch to CONFIGURATION with the arrow keys
3. Press the Menu / OK  key
4. CONFIGURATION level
Switch to ANALOG INPUT with the arrow keys
5. Press the Menu / OK  key
6. ANALOG INPUT level
Switch to MEASURING VALUE OFFSET with the arrow
keys
7. Press the Menu / OK  key
8. Enter offset value
E.g.: T
SET:
T
ACTUAL: (measured)
MEASURING VALUE OFFSET input:
9. Press the Menu/OK  key
10. Press the Return key twice to return to the display
mode.
11. Check values and repeat point 4.2.2 if necessary.
1. Switch on the device
2. Check if the device heats up
3. Press and hold the two keys "Arrow down" &
"Menu" simultaneously.
4. Change level from NONE to COMPLETE.
5. Press the Menu/OK key
6. Controller locked
180°C
184°C
+4°C
V 1.01