Cadel Thermostove 28 Manual De Instrucciones página 40

Failure on electrical devices
Mancata accensione
If the flame does not light up during the switching on or if the smokes temperature does not reach a
suitable value in the foreseen time gap, the thermostove switches off and you will read the words "
L I G H T I N L I G H T I N ".
on the display. Press the key "On/Off" to reset the alarm. Wait until the cooling phase is completed,
clean the brazier and start a new light-up.
Switching off while working
The thermostove suddenly switches off while working (for example because it has run out of pellets
in the tank or because the motor reducer for pellets loading got broken). The thermostove continues
working until the pellets left in the brazier ends. You will then read the words "
display and the stove switches off. Press the key "On/Off" to reset the alarm. Wait until the cooling
phase is completed. Clean the brazier and start a new light-up.
These alarms remind you that the brazier must be cleaned and installed correctly before
switching on the thermostove.
There is no power supply
In the event of a power drop longer than one minute, the thermostove can exhaust some smoke in the
room: this causes no risks. As soon as you have the power supply again, the thermostove will have the
words " B L A C K O U T B L A C K O U T " on the display. After completing the cooling phase, the thermostove will start up
again automatically according to the previous settings.o precedente all'assenza di
Do not attempt to start the thermostove before the required time or it may
get blocked. If this occurs, switch off the switch on the back of the pellet
thermostove stove for 1 minute, set it on again and wait 10 minutes before
starting the thermostove again.
The power socket where the thermostove is connected should be fitted with
"earth connection complying with regulations in force." The Manufacturer shall
not be held responsible for damage to things or people resulting from negligent
installation.
Manual restart thermostat
Intervention in case of danger
In case of fire, disconnect the power supply, use
a fire extinguisher in accordance with, and if
necessary, call the fire department and then contact
an authorised qualified technical assistance
40
no p e l l e t no p e l l e t "on the
elettricità.
RESTART
WATER
NO NO