Cadel Thermostove 28 Manual De Instrucciones página 11

Nominal heat output
Reduced heat output
Water heat output
Reduced water heat output
CO concentration at nominal reference (13% O
CO concentration at reduced reference (13% O
Nominal efficiency
Reduced efficiency
Pellet consumption (min-max)
Heated surface
Flue gas flow rate (min-max)
Draft (min-max)
Flue gas temperature (min-max)
Thermostove water
DHW flow rate
Maximum working pressure
Tank capacity
Smoke outlet tube
Diameter air intake
Connecting heating
Connecting health
Nominal voltage
Nominal frequency
Power consumption max
Thermostove weight
N° Test Report
Ambiental decree n.186
Energetic class
Dust at 13% O
It is recommended that the control of emissions after installation.
With obvious floor capacity evaluation, in the installation premises, a maximum can be deposited of
fuel, which corresponds to approx. 975kg of pellets.
In order to achieve the test report results, please load the performance parameters retained
by the manufacturer and the qualified tecnichian. They will use these parameters once
verified that, during the installation, it is possibile to reproduce the laboratory conditions.
This performance is only reached after 15/20 working hours at nominal power.
PARAMETER
Heat input
IEE
at nominal heat output
2
M. UNITS
kW
kW
kW
kW
kW
) mg/m 3
2
) mg/m 3
2
%
%
Kg/h
mc
g/s
Pa
°C
litri
litres/minute
Bar
Kg
mm
mm
Inch
Inch
V
Hz
W
Kg
mg/m
3
NSAT280 NSAT320
27,34 32,41
25,86 30,48
8,57 8,57
20,35 24,38
6,51 6,51
19,1 18,4
330,9 330,9
94,56 94,03
95,79 95,79
1,825 - 5,575 1,825 - 6,608
515 600
7,9 - 15,1 7,9 - 18,6
6 - 10 6 - 10
77,7 - 113,9 77,7 - 125,2
60
11,5 13,8
2,5
57
100 100
60
3/4
1/2
230 230
50
400 400
280 280
131 131
K 11962013T1
A ++
10,8 16,3
60
2,5
57
60
3/4
1/2
50
11