Preparing For Use; Setting Up The Humidaire 2Ic - ResMed HumidAire 2iC Guia Del Usuario

Preparing For Use

Setting Up the HumidAire 2iC

WARNING
!
Make sure that the CPAP, APAP, or bilevel device is switched off at the
power outlet before connecting the HumidAire 2iC.
1
Remove the front cap from the device. To do this:
1. Press the latch underneath the front cap.
2. While pressing the latch, lift and pull the front cap away from the device. The
front cap should detach from the bottom and right side. The front cap should
still be attached to the left side.
Left side
3. Hold the device down with your left hand. With your right hand, firmly pull
the right side of the front cap out and then up until the whole front cap
comes off.
Notes
To replace the front cap:
•
a. Align the air outlet connector inside the front cap to the air outlet on the
device.
b. Push the front cap firmly onto the device until it clicks into place.
Remember to take the front cap with you when travelling, in case you need
•
to use your CPAP , APAP , or bilevel device without a humidifier.
Latch
Right side
Front cap
Preparing For Use 9