Welding Detection; Electrical Connection; Connecting Options - EMobility eClick Instrucciones De Instalación

58
eClick installation instructions

Welding detection

The signal for welded power contacts is connected
to position 7 of the interface board (see fig. p. 53).
A change -over contact (max. 230 V, 1 A) is available, which
can be used according to the installer's requirements.
Welding detection is an additional feature that must be
connected as standard under IEC 60364 only.
It is connected to a screw terminal.

Electrical connection

Danger
Make sure that the fusing for the
circuits has been disconnected
and there is no voltage across the
fitted components.

Connecting options

The electrical connections (see Scenario A, B, C, or D)
differ depending on whether the eSmartMeter is fitted
or not.
Caution
The eClick can be connected to
both the single- and the
three-phase output from the
sub-distribution. Illustrated,
however, are the three-phase
connections only. If the connection
is single-phase, connect only
L1, N, and PE.
All manuals and user guides at all-guides.com
Caution
The complete product – consisting
of eClick, eBox, and possibly
ePoleDuo – has no facilities for
the attachment of additional
ventilation components.
Caution
The conductor cross-section
may not exceed 10 mm²
(bending radii of the cables).
12 V / 24 V variant
Interface board
Welding COM
indicator
NC NO
Fuse box
GND
e.g. ABB F2C-A1
Installation is greatly simplified when the cable harness
has been prepared for the wiring before being inserted in
the eClick. You are recommended to remove the routing
plates, to lead through the cable, and to pre-bend the
cores according to your configuration. In doing so, consult
the figures on the following pages.
To eClick mains board / eSmartMeter
L1 L2 L3 N
Circuit
breaker
Mechanical
coupling
12 V / 24 V DC
2 A max
L1 L2 L3 N
übersetzen
40 A