All manuals and user guides at all-guides.com
52
eClick installation instructions
Information on mounting
The eClick is secured through three screw holes to the
wall or the ePoleDuo. To start, place the rear side of the
eClick on a flat surface, and remove the contact guard.
The contact guard is clipped without screws to the eClick.
It is replaced after the connection to the power mains.
Use a screwdriver to remove the contact guard. To do
this, insert the screwdriver into the slots on the side of
the contact guard and carefully lift it.
Integrating the eSmartMeter
(optional)
Remove the contact guard from the eClick (cf. previous
page). This will be placed back on the eClick at the end
of the installation. When delivered, the contact guard is
snapped to four points on the eClick.
01
Push the eSmartMeter into the
marked position, and click it in.
02
Insert the loose ends of the
pre-assembled cables into
the top section of the eClick
(mains board).
Click!