Tabla de contenido
Idiomas disponibles
Idiomas disponibles
60
Installation
Reverse the removal procedure.
1. Insert the front axle shaft through the wheel hub
and left fork leg.
2. Tighten the front axle shaft to the specified torque.
Front axle shaft torque:
73.5 N.m (7.5 kgf.m, 54 lbf.ft)
3. First tighten the upper holder nuts until lightly
seated, then tighten the lower axle nuts until
lightly seated.
4. Operate the front brake and pump the fork
several times.
5. First tighten the upper axle holder nuts to the
specified torque, then tighten the lower axle
holder nuts to the same torque:
12 N.m (1.2 kgf.m, 9 lbf.ft)
6. After installing the wheel, apply the brake several
times and then check if the wheel rotates freely.
Recheck the wheel if the brake drags or if the
wheel does not rotate freely.
Check front brake adjustment (page 17).
If the torque wrench was not used for installation,
see your Honda dealer as soon as possible to verify
proper assembly. Improper assembly may lead to loss
of braking capacity.
Rear Wheel Removal
1. Raise the rear wheel off the ground by placing a
support block under the engine.
2. Remove the rear brake adjusting nut (1).
3. Press and release the rear brake pedal and
disconnect the brake rod (2) from the brake arm
(3).
4. Loosen the rear axle nut (4) while holding the
rear axle shaft (6).
( 1 )
( 2 )
(3)
(4)
CRF150F
(1) Rear brake
adjusting nut
(2) Brake rod
(3) Brake arm
(5)
(4) Rear axle nut
(5) Chain adjusters
Capítulos
Tabla de contenido
