Pleasant Hearth OFG419T Manual Del Usuario página 13

ASSEMBLY INSTRUCTIONS
9. Table Installation
9-1. Line up holes in assembled table with
corresponding screw holes in base assembly.
9-2. Insert eight M6x12 bolts (AA) through the holes
under the table into the corresponding screw holes
in the posts (F) using the wrench (HH). Tighten with
screwdriver (II).
Hardware Used
AA
Bolt M6 X 12
Phillips Screwdriver
II
Wrench
HH
10. Burner Assembly (C) Installation
Make sure the control knob faces the front side of the
unit where the doors are located. Line up holes in the
burner assembly (C) with screw holes on the table.
Insert four M5 X 12 screws (DD) through the holes.
Fasten with a screwdriver (II).
Hardware Used
DD
Screw M5 X 12
Phillips Screwdriver
II
9-1
9-2
X 8
10
C
X 4
13
AA
F
DD