Sony HST-SE581 Manual De Instrucciones página 15

6
Repeat steps 2 to 5 to store other
stations.
To change the preset number
Start over from step 2.
To change the AM tuning interval
(except for European model)
The AM tuning interval is factory-preset to
9 kHz. To change the AM tuning interval,
press BAND repeatedly to select AM, then
turn off the power. While holding down
MEMORY, turn the power back on. When
you change the interval, all the preset stations
will be erased. To reset the interval, repeat
the same procedure.
Tips
• If "MEMORY" disappears before you select the
preset number, press MEMORY again.
• The preset stations are retained for a few days
even if you pull off the power cord or if a power
interruption occurs.
Scanning the preset
memory
POWER
1
Press BAND repeatedly to select FM
or AM.
2
Press MEMORY SCAN.
A preset number flashes in the display.
3
Press TUNING + or –.
Press + to scan higher preset numbers.
Press – to scan lower preset numbers.
You will hear each preset station for
about four seconds.
4
Press MEMORY SCAN again as
soon as the station you desire is
tuned in.
This stops the memory scan.
Tip
While scanning preset stations, a certain station with
a weak signal may be skipped. Tune in the station
manually.
2,4 3 1
MHz
Preset number
EN
15