Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Magazine
For 7/8", 1" and
1-1/4" (22 mm,
25 mm, 32 mm)
3
For 1-1/2" (38 mm)
For 1-3/4" (45 mm)
Plate
NOTE: Before loading nails in the magazine, adjust the
nail holder. If the magazine cover is forcibly closed
without adjusting the nail holder correctly, the nail
holder may be damaged.
(3) Place the nail coil in the magazine.
Insert the first nail into the magazine opening.
Magazine Opening
First Nail
Nail
(4) Close the magazine cover.
(5) 1 Uncoil enough nails to reach the driving hole.
2 Insert the first nail into the driving hole and the
second nail between the two pawls of the feeder.
3 Fit the nail heads in the guide slot.
Guide Surface
Driving Hole
First Nail
2 3
Nail Guide
2
Pawl
NOTE: Be careful not to deform the collated wires and
not to disengage the nails with the guide surface.
Otherwise, the nail guide will not close correctly.
4 Pulling the nails to the right
After checking and making sure that the magazine
cover is closed, hook your fingers on the nail guide
Nail Holder
1
2
Magazine
Guide Slot
1
4
Feeder
— 13 —
and knob, turn the nail guide clockwise while
pressing the knob downward, and then close the
nail guide completely.
Knob
4
Nail Guide
(6) Lock the knob completely.
The Nailer is now ready to operate.
NAILER OPERATION
Read section titled "SAFETY"(pages 4 – 7).
DANGER
Always wear eye protector with side shields which
conforms to ANSI Z87.1 specifications.
WARNING
Never point Nailer toward yourself or anyone else.
Never carry with finger on trigger.
Remove finger from trigger when not driving nails.
Never place your hands or feet closer than 8 inches
(200 mm) from firing head when using.
Do not drive nails on top of other nails or with
Nailer at too steep of an angle; nails can ricochet
and hurt someone.
In order to avoid double fire or unwanted ejection
of a nail due to bouncing of the Nailer.
1) do not push Nailer on workpiece with strong
force;
2) take Nailer away from workpiece using recoil;
3) release trigger quickly when performing trigger
fire.
Do not drive nails into thin boards or near corners
and edges of workpiece. Nails can be driven
through or away from workpiece and hit someone.
Never drive nails from both sides of a wall at the
same time. Nails can be driven into and through
the wall and hit a person on the opposite side.
Never use Nailer which is defective or operating
abnormally.
English
4
Magazine Cover
Tabla de contenido
