Nailer Operation - Hitachi NV 45AC Manual De Instrucciones

English
NOTE: Before loading nails in the magazine, adjust the
nail holder. If the magazine cover is forcibly closed
without adjusting the nail holder correctly, the nail
holder may be damaged.
(3) Place the nail coil in the magazine.
Insert the first nail into the magazine opening.
Magazine Opening
First Nail
Nail
(4) Close the magazine cover.
(5) Grip the nail guide and knob with finger.
Press the knob down and swing the nail guide open.
Magazine Opening
Knob
Nail Guide
First Nail
(6) 1 Uncoil enough nails to reach the driving hole.
2 Insert the first nail into the driving hole and the
second nail between the two pawls of the feeder.
3 Fit the nail heads in the guide slot.
Driving Hole
First Nail
Nail Guide
Pawl
Magazine
Guide Slot
2 3
Feeder
2
Guide Surface
NOTE: Be careful not to deform the collated wires and
not to disengage the nails with the guide surface.
Otherwise, the nail guide will not close correctly.
4 Pulling the nails to the right, swing the nail guide
closed.
(7) Lock the knob completely.
The Nailer is now ready to operate.

NAILER OPERATION

Read section titled "SAFETY"(pages 4 – 6).
Always wear eye protector which conforms to
ANSI Z87.1 specifications.
Never point Nailer toward yourself or anyone else.
Never carry with finger on trigger.
Remove finger from trigger when not driving nails.
Never place your hands or feet closer than 8 inches
(200 mm) from firing head when using.
Do not drive nails on top of other nails or with
Nailer at too steep of an angle; nails can ricochet
and hurt someone.
In order to avoid double fire or unwanted ejection
of a nail due to bouncing of the Nailer.
1) do not push Nailer on workpiece with strong
force;
2) take Nailer away from workpiece using recoil;
3) release trigger quickly when performing trigger
fire.
Do not drive nails into thin boards or near corners
and edges of workpiece. Nails can be driven
through or away from workpiece and hit someone.
Never drive nails from both sides of a wall at the
same time. Nails can be driven into and through
the wall and hit a person on the opposite side.
Never use Nailer which is defective or operating
abnormally.
Do not use Nailer as hammer.
Disconnect air hose from Nailer when:
1) it is not in use;
2) leaving work area;
3) moving it to another location; and
4) handing it to another person.
— 12 —
DANGER
WARNING