Husqvarna K 1270 Manual De Instrucciones página 27

Replacing the drive belt
WARNING! Never start the engine when
!
the belt pulley and clutch are removed
for maintenance. Do not start the
machine without the cutting arm or
cutting head fitted. Otherwise the clutch
could come loose and cause personal
injuries.
• First release the two bolts and then the adjuster screw
to release the belt tension.
• Now unscrew the bolts and dismantle the belt guard.
• Remove the belt from the belt pulley.
• The cutting head is now loose and can be removed
from the machine.
• Remove the nut. Remove the side cover.
• Replace the drive belt.
• Assemble in the reverse order as set out for
dismantling.
MAINTENANCE
Carburetor
The carburettor is equipped with fixed needles to ensure
the machine always receives the correct mixture of fuel
and air. When the engine lacks power or accelerates poorly, do the following:
• Check the air filter and replace if necessary. When this
does not help, contact an authorised service
workshop.
Adjusting the idle speed
!
Start the engine and check the idling setting. When the
carburetor is set correctly the cutting blade should be still
while engine is idling.
• Adjust the idle speed using the T screw. When an
adjustment is necessary, first turn the screw clockwise
until the blade starts to rotate. Now turn the screw
anti-clockwise until the blade stops rotating.
Rec. idle speed: 2700 rpm
Starter housing
Checking the starter cord
• Loosen the screws that hold the starter against the
crankcase and remove the starter.
• Pull the cord out about 30 cm and lift it into the cut-out
in the periphery of the starter pulley. When the cord is
CAUTION! If the idle speed cannot be
adjusted so that the cutting attachment
stops, contact your dealer/service
workshop. Do not use the machine until
it has been correctly adjusted or
repaired.
T
–
English 27